¶ How to Print
Print settings for any of the Root CNC machine is key for a long lasting - high performance CNC machine. Below are the setting I used:
Resolution: 0.25-0.35mm
Infill: 50-60%
¶ Notes:
- Strength is key! use the hardest settings possible
- Print with 3-4 perimeters
- Print with ABS, PETG PLA will be fine though your mileage may vary (I am worried about the low glass transistion point of PLA being too low for the motors)
¶ Base and Y axis assm- Foot
¶ Base and Y axis assm-1 Y-Axis Bar Mount Idler
¶ Base and Y axis assm-1 Y-Axis Bar Mount
¶ Base and Y axis assm-1 Y-Axis Drag Chain
¶ Base and Y axis assm-1 Y-Axis Motor Mount
¶ Ramps controller-1 Ramps Case Base
¶ Ramps controller-1 Ramps Case Lid
¶ X carriage-1 linear rail 90 bearing mount Y-Axis Carriage
¶ X carriage-1 X-Axis Carriage Drag Chain Mount Idler
¶ X carriage-1 X-Axis Motor Mount
¶ X carriage-1 Z carriage-1 Spindle Lower Clamp
¶ X carriage-1 Z carriage-1 Spindle Upper Clamp
¶ X carriage-1 Z-Axis Motor Mount
¶ Y gantry assm-1 Dirt Cover
¶ Y gantry assm-1 X-Axis Belt Clamp
¶ Y gantry assm-1 X-Axis Box Bar Mount
¶ Y gantry assm-1 X-Axis Carriage Y Drag Chain Mount
¶ Y gantry assm-1 Y Drag Chain Carriage
¶ Y gantry assm-1 Y Motion Bearing Mount
¶ Y gantry assm-1 Y-Axis Belt Clamp GT2
